Cambex AIX PC2000 Manuel d'utilisateur télécharger pdf (Page 11)

FibreQuik - Fibre Channel Adapter User Guide

lscfg -vl scsi4 should print more information for a card:

DEVICE LOCATION DESCRIPTION

scsi4 20-58 Cambex ...

Manufacturer................CAMBEX

Machine Type and Model......PC1000F

ROS Level and ID............V2.01.19

Serial Number............... 579

Displayable Message.........Cambex ...

Network Address.............500502E010000243

Device Specific.(Z0)........Build:TMFtL

Device Specific.(Z1)........1.5.13.0

Device Specific.(YL)........P1-I1/Z1

lsattr -El scsi4 should print the attributes for a card.

These are also displayed by SMIT in Change / Show

Characteristics of an Adapter.

bus_io_addr Bus address of board I/O registers

bus_intr_lvl Bus interrupt level

intr_priority Interrupt priority

id Adapter card loop ID

exec_throttle Max commands per port

max_iocb Max bufers per port

retry_delay Delay amount after bus reset (sec)

login_on_lip Login all devices after LIP

full_duplex Use open full duplex (OPNyx)

topology_list Prioritized topology list

frame_size Max payload frame length

infinity Command timeout infinity (sec)

dma_window DMA window size for 64 bit PCI

GHz Fibre channel rate in GHz

sw_fc_class Class of service

devtype_exclude SCSI device type exclude list

logout_delay Delay amount after device logout

BDR_mask Mask bus device resets

• ID may be used to set a hard card loop ID if required.

• Exec_throttle may be used to limit simultaneous I/Os to avoid

"device busy" errors.

• Max_iocb is not used.

- 9 -

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Cambex AIX PC2000 Manuel d'utilisateur Page 11