Cambex AIX Guide d'installation télécharger pdf (Page 17)

96107 Fourth Edition 11

StorageTek Proprietary

AIX Host Installation Preparation

command:

lslpp -L devices.fcp.disk.array.*

If there is no IBM storage array connected in the architecture, we

recommend removing the AIX packages at the appropriate time in the

upgrade process as follows.

installp -u devices.fcp.disk.array.*

Note: Do not do the command at this time because it needs to be

done in the proper sequence of the software removal process.

This will allow you to map and use the access LUN for inband storage

management operations if you chose. If AIX software patches are

applied, check if the packages were reinstalled and remove them if

they were.

■ AIX Host Installation Preparation

The following sections provide the necessary configuration, hardware and

software requirements, and the things you should know—to prepare and

install FlexLine™ 200 Series and 300 Series storage systems. Please read

this information to minimize installation problems.

Hardware

Check that you have the appropriate HBA for your planned configuration:

• Cambex PC2000 (or PC1000) or IBM 6227/6228/6239 (for both failover

and non-failover configurations).

Software

Check to see that you have the appropriate host software levels, as indicated

below.

For all AIX versions you should be at the latest maintenance level and latest

emergency patches because various file system (jfs2), HACMP, and HBA

device driver issues have been recently (and are still being) corrected.

Cambex HBA drivers – version 2.5.10.5 or higher (standard) for AIX 5.1 and

5.2, Cambex 2.0.10.5 for AIX 4.3.3.

Cambex DPF Failover drivers – version 1.5.3.33 package or higher for AIX 5.1

and 5.2; Cambex 1.0.3.33 package or higher for AIX 4.3.3

Note: The Cambex failover driver must be individually purchased for each

host. Distribution without purchase is illegal.

SN4116/4108 Switch firmware – 2.4.1c or later

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Pas de commentaire

Cambex AIX Guide d'installation Page 17