Cambex AIX Guide d'installation télécharger pdf (Page 19)

96107 Fourth Edition 13

StorageTek Proprietary

AIX Host Installation/Upgrade Procedures

tar xvf stkODM_R4.2.tar (or higher)

5. install the odm entries using:

./install_stkODM

6. If the earlier architecture decision concerning the access LUN mapping

versus removal of software packages devices.fcp.disk.array.*

was to remove the software packages, then remove the software

packages now with:

installp -u devices.fcp.disk.array.*

If this is a new install, a reboot is necessary at this time to pick up the ODM

changes. Install/upgrade HBAs while the system is down for this reboot.

Remove/Install/Upgrading the Cambex DPF Failover Driver

If you are using the Cambex DPF failover solution, perform the following

steps.

1. Uninstall the old Cambex DPF failover driver (if installed) with the following

command.

installp –u cbxdpf.driver.obj

2. If the earlier architecture decision concerning the access LUN mapping

versus removal of software packages devices.fcp.disk.array.*

was to remove the software packages, then remove the software

packages now with:

installp -u devices.fcp.disk.array.*

3. FTP from the CRC to the target AIX system and uncompress the driver file

if necessary, or mount the Cambex Failover Driver CD and cd to the

directory that contains the driver file,

and install it using:

installp –acd filename.image all

where filename is the filename of the latest Cambex DPF failover driver for

your version of AIX, for example:

cbxdpf_1_0_3_33.image (AIX 4.3 version)

cbxdpf_1_5_3_33.image (AIX 5.1/5.2 version)

4. The DPF license will need to be added at this time.

Apply the license key.

If you have the license key, run the following command.

smitty devices >> Cambex Dynamic Path Management >>

Manage Licensing >> Add License from the Keyboard.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Pas de commentaire

Cambex AIX Guide d'installation Page 19